The steering will be the easiest, just add 1 or 2 motor 2’s then 2 wing panels (1×2) to each motor 2 and set it to servo and change the hotkeys to “A” and “D” to steer.
thus, How do you hover in a plane crazy?
First, place a hover thruster at a fixed place to keep it fixed ( turn it everywhere you want it to thrust your build to ). Next, configure it with max speed and drag for recommend stability and performance ( best for lowest speed if build is under 50 blocks ffs ). Finally, place a piston facing the the hover thruster.
Besides, How fast can you go in Plane Crazy?
But all of this come at a cost, and that is speed. This plane can go at 200 mph with the super rocket engines and nearly at 1200-1500 with the built in conveyor engine.
then What do friction blocks do in Plane Crazy? Usage. so far, there is one known use, to keep vehicles from doing wheelies by placing them on the underside or on the front. They are also used to keep vehicles that use engines to turn from over turning, and to stick more to the ground. They can also get edited to generate more or less friction.
so that How do you build a submarine in Plane Crazy?
A submarine, or submersible, is a vehicle able to alternate between traveling on the water’s surface or submerged beneath it.
…
When Surfaced
- Hold W to dive.
- After holding W for about 2 seconds, hold F.
- When approaching desired depth, hold S and release F.
- Make small changes with W and S until the submarine is level.
How do you make a magnet drive in a plane crazy?
Open the configuration tool.
- Type in the backward slot W.
- Type in the forward slot S.
- Modify the range to 25.
- Set the strength to the desired speed using the following formula. Formula: speed = magnet strength x 100.
Table of Contents
What is hover thruster?
Overview. The hover thruster is a propulsion block, used to make builds to hover on land and water. it’s roughly the size of a half-block, and it attaches on 5 sides. yet, even though this makes building hovering vehicles much easier, it still doesn’t replace other ways of hovering.
What does the pilot seat do in Plane Crazy?
The Pilot Seat lets the builder of the vehicle operate it. In order for the vehicle to move, or any of the keybinds to work, the builder MUST sit in the pilot seat. When you press the green “Flight Button” please don’t sit in the pilot seat. You will be teleported in to the seat.
What does motor 2 do in Plane Crazy?
Motor 2 is a motor that turns to the direction of your cursor. It is commonly used for turrets, missile launching creations, and in planes and other contraptions to make it turn where the cursor is.
What is a shredder bug Plane Crazy?
Shredder Bugs are probably the most annoying things in the game, close to lag machines and the little trail things that go crazy. They are compromised of either toxic 9 year olds with crap builds, those who cant make a PVP weapon properly, and trolls that want to see other people suffer for their own entertainment.
What is the most powerful engine in Plane Crazy?
Large rocket engine is one of the most strong engines.
How Big Is a Plane Crazy block?
Control Surfaces are complex parts that shift, allowing you to control your aircraft. Control Surface 1×1 – In the size of a 1×1 block hitbox.
How do you make a torpedo in an airplane crazy?
first, begin by placing super rocket engine. then, place 3 explosive blocks. then place motor 2 on the 2nd explosive. place wings to make it work in water and in air.
What do ballast blocks do in Plane Crazy?
Ballast Block – Can be used to increase the weight on one part of creation.
What does the camera do in Plane Crazy?
The camera is used for aiming on guns and turrets, and can be used on a vehicle to see where it is going, and to make unmanned vehicles, like spy drones, tanks, and submarines.
How do airplane springs go crazy?
Uses. You can use the spring if you want something that will shoot you up to gain altitude. Other uses for it is making a music machine where you put the pattern spring, block, speaker and so on. Another use for it is if you make 4 springs (or more) at the bottom of a flat plate and make it bouncy like a normal spring.
What is Torque Plane Crazy?
Torque: The torque provided by the motor, or how persistent the rotation is when met with an opposite force.
How do you make a conveyor engine in a plane crazy?
To make a Simple Conveyor engine, place down a piston facing forwards where the arrow points. The next step is to place a conveyor infront of the Piston you placed down, the black part of the Conveyor on the ground or any build, and thats it, you can configure it to whatever you want.
What is motor lock Plane Crazy?
What is Motor Locking. When configuring a motor to be powered off and locked the head of the motor will contract 0.5 blocks instantly after the creation has loaded in play mode. The retraction can be delayed using parts that keep it welded, such as the Explosive Block or Disconnector part.
How do you use the guns in Plane Crazy?
Guns. Guns are the second choice of weapon for many players due to the fact you can hold down the left mouse button and spray bullets into your enemy.
How do you make a magnet engine in Plane Crazy?
A magnetic engine is a player-made engine that exploits the physics of magnet parts.
…
Building
- Place two suspension blocks horizontal on the ground.
- Place three half blocks on the front of the suspensions.
- Place three magnets at the back of the suspension.
How do you make a plane missile in Roblox crazy?
To make a simple missile, follow this guide. First, place a super rocket engine facing up (so it flies up). Place 1×1 delta wings on the upper part of the super rocket engine and 1×1 control surfaces below those delta wings. Then place seven blocks of explosives on top.
How do you make the rope longer in a plane crazy?
The Rope is a kind of block that is able to extend and retract by pressing buttons. It Is fairly long. It’s size in the building mode is 1×2.
What does a disconnector do in Plane Crazy?
The disconnector is a part in Plane Crazy that is used to disconnect one part of a build from the other. An example of disconnectors in use.
Discussion about this post